An aptamer-assisted nanopore strategy with a salt gradient for direct protein sensing.

Nanopore sensing is at the forefront of the technological revolution of the protein research field and has been widely used in molecular diagnosis and molecular dynamics, as well as for various sequencing applications. However, direct protein sensing with biological nanopores is still challenging owing to the large molecular size. Here, we propose an aptamer-assisted nanopore strategy for direct protein sensing and demonstrate its proof-of-concept utilities by experiments with SARS-Cov-2 nucleocapsid protein (NP), the most abundantly expressed viral protein, that is widely used in clinical diagnosis for COVID-19. NP binds with an oligonucleotide-tailed aptamer to form a protein-DNA complex which induces a discriminative two-level pattern of current blockades. We reveal the potential molecular interaction mechanism for the characteristic blockades and identify the salt gradient condition as the dominant factor of the phenomenon. Furthermore, we achieve a high sensitivity of 10 pM for NP detection within one hour and make a preliminary exploration on clinical diagnosis. This work promises a new platform for rapid and label-free protein detection.

Low-noise and high-speed trans-impedance amplifier for nanopore sensor.

The small current detection circuit is the core component of the accurate detection of the nanopore sensor. In this paper, a compact, low-noise, and high-speed trans-impedance amplifier is built for the nanopore detection system. The amplifier consists of two amplification stages. The first stage performs low-noise trans-impedance amplification by using ADA4530-1, which is a high-performance FET operational amplifier, and a high-ohm feedback resistor of 1 GΩ. The high pass shelf filter in the second stage recovers the higher frequency above the 3 dB cutoff in the first stage to extend the maximum bandwidth up to 50 kHz. The amplifier shows a low noise below sub-2 pA rms when tuned to have a bandwidth of around 5 kHz. It also guarantees a stable frequency response in the nanopore sensor.

Analysis of starch dissolved in ionic liquid by glass nanopore at single molecular level.

In this paper, the glass nanopore technology was proposed to detect a single molecule of starch dissolved in ionic liquid [1-butyl-3-methylimidazolium chloride (BmimCl)]. Firstly, the influence of BmimCl on nanopore detection is discussed. It is found that a certain amount of strong polar ionic liquids will disturb the charge distribution in nanopores and increase the detection noise. Then, by analysis of the characteristic current signal of the conical nanopore, the motion behaviour of starch near the entrance of the nanopore was studied and analysis the dominant ion of starch in the BmimCl dissolution process. Finally, based on nuclear magnetic resonance (NMR) and Fourier transform infrared (FTIR) spectroscopy simply discussed the mechanism of amylose and amylopectin dissolved in BmimCl. These results confirm that branched chain structure would affect the dissolution of polysaccharides in ionic liquids and the contribution of anions to the dissolution of polysaccharides are dominant. It is further proved that the current signal can be used to judge the charge and structure information of the analyte, and the dissolution mechanism can be assist analyzed at the single molecule level.

DNA nanostructure-assisted detection of carcinoembryonic antigen with a solid-state nanopore.

In this paper, a novel detection technique for tumor marker carcinoembryonic antigen (CEA) has been developed by using a solid-state nanopore as a tool. The system utilizes the specific affinity between aptamer-modified magnetic Fe3O4 and CEA, rather than directly detecting the translocation of CEA through the nanopore. The aptamer-modified magnetic Fe3O4 was hybridized with tetrahedral DNA nanostructures (TDNs), and TDNs were released after CEA was added. We investigate the translocation behavior of individual TDNs through solid-state nanopores. The frequency of the blockage signals for TDNs is recorded for indirect detection of CEA. We realized the detection of CEA with a concentration as low as 0.1 nM and proved the specificity of the interaction between the aptamer. In addition, our designed nanopore sensing strategy can detect CEA in real samples.

Highly sensitive α-hemolysin nanopore detection of MUC1 based on 3D DNA walker.

Mucin 1(MUC1) is an effective marker of breast cancer, so it is of great significance to develop a simple, sensitive and highly selective MUC1 detection sensor. Herein, we constructed a label-free nanopore biosensor for rapid and highly sensitive detection of MUC1. The presence of MUC1 triggered the modification of the DNAzyme walking chain on the surface of Fe3O4 nanoparticles and separation from the aptamer. In the presence of Zn2+, DNAzyme catalyzed hydrolytic cleavage of the hairpin substrate at the scissile rA. The DNAzyme was divided into two fragments and ssDNA was released. ssDNA products from the hairpin substrate can generate a current blocking signal during α-hemolysin nanopore testing. The frequency of signature events showed a linear response toward the concentration of MUC1 in the range of 0.01 nM-100 nM. The sensing system also exhibited high selectivity against other protein and can be used for the detection of real sample.

Single-Molecule Identification of the Conformations of Human C-Reactive Protein and Its Aptamer Complex with Solid-State Nanopores.

Human C-reactive protein (CRP) is an established inflammatory biomarker and was proved to be potentially relevant to disease pathology and cancer progression. A large body of methodologies have been reported for CRP analysis, including electrochemical/optical biosensors, aptamer, or antibody-based detection. Although the detection limit is rather low until pg/uL, most of which are time-consuming and relatively expensive, and few of them provided CRP single-molecule information. This work demonstrated the nanopore-based approach for the characterization of CRP conformation under versatile conditions. With an optimized pore of 14 nm in diameter, we achieved the detection limit as low as 0.3 ng/µL, voltage polarity significantly influences the electro-osmotic force and CRP translocation behavior, and the pentameric conformation of CRP may dissociate into pro-inflammatory CRP isoforms and monomeric CRP at bias potential above 300 mV. CRP tends to translocate through nanopores faster along with the increase in pH values, due to more surface charge on both CRP and pore inner wall and stronger electro-osmotic force. The CRP could specifically bind with its aptamer of different concentrations to form complexes, and the complexes exhibited distinguishable nanopore translocation behavior compared with CRP alone. The variation of the molar ratio of aptamer significantly influences the orientation of CRP translocation. The plasma test under physiological conditions displayed the ability of the nanopore system on the CRP identification with a concentration of 3 ng/µL.

Comparison Study on Single Nucleotide Transport Phenomena in Carbon Nanotubes.

To be considered as a promising candidate for mimicking biological nanochannels, carbon nanotubes (CNTs) have been used to explore the mass transport phenomena in recent years. In this study, the single nucleotide transport phenomena are comparatively studied using individual CNTs with a length of ∼15 µm and diameters ranging from 1.5 to 2.5 nm. In the case of CNTs with a diameter of 1.57-1.98 nm, the current traces of nucleotide transport are independent with the metallicity of CNTs and consist of single peak current pulses, whereas extraordinary stepwise current signals are observed in CNT with a diameter of 2.33 nm. It suggests that there is only one molecule in the nanochannel at a time until the diameter of CNT increases to 2.33 nm. Furthermore, it also demonstrates that the single nucleotides can be identified statistically according to their current pulses, indicating the potential application of CNT-based sensors for nucleotides identification.

Enzyme Hinders HIV-1 Tat Viral Transport and Real-Time Measured with Nanopores.

HIV-1 Tat protein, an intercellular transporter with a determinant function of delivering "information-rich" molecules in viral multiplication, was tryptic-hydrolyzed and real-time single molecule-monitored in a transmembrane pore. The electrokinetic studies revealed the catalytic and inhibitory effects on enzymatic digestion associated with Ca2+ and Cu2+ ions, respectively, in response to binding interactions with trypsin. Our strategy permits accurate and distinguishable sensing of Ca2+ and Cu2+via an enzyme assay. In addition, considering the closer mimic of the real situation of HIV spread, measurements in the serum and on cells were also investigated. Transmembrane current measurements together with fluorescence microscopy imaging indicated the potential to perturb the Tat transport in the serum environment and on cells. Because the involved Tat proteolysis should prevent the occurrence of viral delivery, the presented method probably enables efficient hindrance to HIV-1 infection, in complementary to current traditional treatments.

A novel dielectric breakdown apparatus for solid-state nanopore fabrication with transient high electric field.

The dielectric breakdown used to fabricate solid-state nanopores has separated the device from capital-intensive industries and has been widely adopted by various research teams, but there are still problems with low production efficiency and uncertain location. In this work, based on the transient breakdown phenomenon of nanofilms, a new type of dielectric breakdown apparatus for nanopore fabrication is reported. It integrates both nano-manipulation technology and dielectric breakdown nanopore fabrication technology. The nanometer distance detection method and circuit are introduced in detail. The generation principle and procedures of the transient high electric field are explained step by step. The characterization of the nanopores shows that this apparatus can fabricate sub-2 nm nanopores at a pre-located position. Besides, the nanopore diameter can be easily adjusted by setting the transient high electric field value.

Nanopore Fabrication via Transient High Electric Field Controlled Breakdown and Detection of Single RNA Molecules.

The fabrication of nanopores through a dielectric breakdown method, achieved by simple, low-cost desktop setups, has promoted the research of solid-state nanopore sensing. This paper reports a method for fabricating nanopores. This method uses transient high electric field controlled breakdown (THCBD) to form electric-field-dependent nanopores with different diameters in the order of milliseconds. By manipulating a micropipette with a high electric field to establish the meniscus contact with the SiNx membrane, nanopores can be formed through an "auto-brake" fabrication process. Compared with the traditional dielectric breakdown, THCBD can greatly shorten the breakdown time and form pores of different sizes under higher electric fields without causing additional damage to the SiNx membrane. The nanopores formed by this method can be successfully used to detect two types of RNA molecules. One is transfer RNA from yeast extract and the other is a synthetic RNA oligonucleotide fragment (rArArArArArArArArArArArA).

Covalent Modification of Silicon Nitride Nanopore by Amphoteric Polylysine for Short DNA Detection.

In this work, we demonstrate a chemical modification approach, by means of covalent-bonding amphoteric poly-l-lysine (PLL) on the interior nanopore surface, which could intensively protect the pore from etching when exposed in the electrolyte under various pH conditions (from pH 4 to 12). Nanopore was generated via simple current dielectric breakdown methodology, covalent modification was performed in three steps, and the functional nanopore was fully characterized in terms of chemical structure, hydrophilicity, and surface morphology. I-V curves were recorded under a broad range of pH stimuli to evaluate the stability of the chemical bonding layer; the plotted curves demonstrated that nanopore with a covalent bonding layer has good pH tolerance and showed apparent reversibility. In addition, we have also measured the conductance of modified nanopore with varied KCl concentration (from 0.1 mM to 1 M) at different pH conditions (pHs 5, 7, 9, and 11). The results suggested that the surface charge density does not fluctuate with variation in salt concentration, which inferred that the SiN x nanopore was fully covered by PLL. Moreover, the PLL functionalized nanopore has realized the detection of single-stranded DNA homopolymer translocation under bias voltage of 500 mV, and the 20 nt homopolymers could be evidently differentiated in terms of the current amplitude and dwell time at pHs 5, 8, and 11.

High-speed AFM for scanning the architecture of living cells.

We address the modelling of tip-cell membrane interactions under high speed atomic force microscopy. Using a home-made device with a scanning area of 100 × 100 µm(2), in situ imaging of living cells is successfully performed under loading rates from 1 to 50 Hz, intending to enable detailed descriptions of physiological processes in living samples.